I've been looking around for tools to remove and replace some 6901 pivot bearings in an old Intense Spider.
I know of one shop that uses the Motion Pro. Not sure which exact tool. I think it's the one with the long rod and the collets in Metric ( around $75)
The RWC tools are like mini presses,and are offered each with a different drift size for specific bearing sizes. So Getting the most common RWC tools would cost a bit considering that their around $39 each.

Any one have experience with these or any other method.

One other tool looking at is the Enduro BBT-200. I think it's about $200.

Or should this go in the Tool Time forum??