so i just picked up and lg-1 and need some help. I am currently running saints with 2 rings and a bashguard. I'm assuming that I will need to run my chainring where my bash guard currently is with the lg-1? I've also hear you have to grind off the small ring hole to fit the guide...is this true? Last question is what are some good and light chainrings to look at with this set-up and what bolt pattern am I going to need? Thanks.
LG-1 is a single ring setup as far as I know. Unless someone found a way to run dual rings. Look at the DRS for your setup. And the e13 chainrings are damn light to compliment that setup. Good luck man.
I know the lg-1 is a single ring guide...I'm converting to a single ring
with that being said I was tring to figure out which ring to run and what the bolt pattern was because i wanted to order a ring and am at work and don't have the bike in front of me...So I need a 104 ring and my question is it goes where the biggest ring or bash guard would normally go when used with the lg-1 right?
Good Looks on that MTB...never even crossed my mind ot look for online instructions...I'm a retard today
The other issue I have is if I am going to need to grind the drive side crank arm for clerance issues...I have heard of this but am not sure
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Mountain Bike Reviews Forum
15.4M posts
515.2K members
Since 1990
A forum community dedicated to Mountain Bike owners and enthusiasts. Come join the discussion about bike parts, components, deals, performance, modifications, classifieds, trails, troubleshooting, maintenance, and more!