Hi there,

Problem with my 2011 Easton Haven rear wheel... it has only done about 100 miles. The bearing preload adjustment seems to do itself up super tight, effectively locking the rear axle up completely. Freehub works fine, but the wheel cannot be turned by the pedals.

I take the wheel out, loosen up the adjustment by hand and it spins freely in my hands again, put it back on the bike, and within a couple of turns of the crank it is locked up again. QR is done up as tight as it ever was.

The LBS have done a hub service today and other than them loosening off the adjuster again, there was nothing to report.

Any ideas?

Thanks in advance!