1st thing tomorrow morning, I finish hard tacks and remove the frame from the jig.
Then I will do a quick fit check of the rear tire ( we'll see how big we can go, eh ?) and check for crank clearance with the seat stays as moving them forward because of the Cru's was trick.
I am pretty sure we'll be good though, if not, I will have to do some more bending, or change the entire stay, no biggie. I will post pic's after the weld-up of the frame with tires, fork and bars, and seat ( I stuck a seat in today when I got home, geez it looks fvcking sick cocked back over where our rear tire will sit....sheeeeit !!
Also i am leaning toward calling the frame the 10-74.
See ya tomorrow,
P.S. The seat tube/ top tube/ stay intersection is 8'' from the center of the BB.
Results 1 to 9 of 9
Thread: Fit check, and weld-up