Minoura Workman Pro Stand - 20mm?

[joeyjoedotorg]

Hi all, I was thinking about getting this stand from treefort bikes:

http://www.treefortbikes.com/277_333...ing-Gauge.html

does anyone have experience with using 20mm adapters with this stand? Also, does the knob move both calipers in and out? I was hoping it was going to be like the TS-2 in that regard.

Thanks!

-Joe

[Stevo the Devo]

The knob does move both calipers, but the whole caliper body can move sideways, so a dishing tool is still required. I have not used 20mm adapters on mine, but I see no reason why they won't work. The other alternative is just to put a QR through the hub and clamp it between the axle mounts; works just fine. Cheers, Steve

[joeyjoedotorg]

Sweet, thanks for the confirmation; I've actually already ordered it and am expecting it on tuesday.

[spookygeek]

I just did my first set of wheels using this stand. For dishing I just put a zip tie around one leg and cut it off close to there the wheel was. Flipped the wheel around and rechecked. I just went back and forth until I had no gap - easy cheap dishing tool.

Thanks,

-Brent