Mountain Bike Reviews Forum banner

Enduro suspension setup

1K views 9 replies 9 participants last post by  GuruAtma 
#1 ·
I would be very grateful if any Enduro riders would post info on their suspension setups.
Air pressure, rebound adjustment and rider weight if possible.

I have an 04 Expert that I am constantly tweaking.
 
#7 ·
I also ride an '04 Enduro Expert

I also fiddle with the suspension settings. So I can't claim to have found the perfect mix, however, my current set up is about like this:

rear float RL@160lbs damping at one click faster than center

TALAS RL @75lbs damping centered (It feels less harsh with the damping slowed a bit, but handles better at speed with slightly faster rebound)

In gear I'm about 185lbs.
 
#9 ·
03 Enduro Pro setup...

I have the 03 Enduro Pro with Marz All Mtn 1 130-150mm, Fox Float RL and BETD linkage plate.

Rider weight: 180 lbs with gear
Fork: 25psi (25% sag) at 150mm (All Mtn1 is a low pressure fork) (I ran the TALAS at 65 - 70 psi and 3 clicks from fastest rebound)
Marz Fork Rebound: 5 clicks from fastest rebound
Shock: 180psi w/ BETD link (6" travel), 160psi w/ stock link (25% sag) (5" travel)
Shock Rebound: 5 clicks from fastest rebound
 
#10 ·
I have an 04 expert and I go by sag rather than pounds of pressure. I keep pumping till I have about .5 inches of sag (or about 25% of the stroke). For rebound I ride off a tall curb sitting down. As long as I only "bounce" once, then I know I'm good. I keep the rebound as fast as it goes without getting more than one "bounce" off a 10" curb.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top