Hi all,
just purchased some lightly used 888's and want to strip them down to regrease etc before use. Any idea where I can get a workshop manual? I'm used to running 40's which were straight forward, so hope these turn out to be the same.
Also, I've noticed that these won't extend back fully after being compressed (can pull fork up 3-5mm) unless I have preload fully cranked. Any idea on what this may be? (stiction?) Currently running factory med spring.
Cheers,
Dave
just purchased some lightly used 888's and want to strip them down to regrease etc before use. Any idea where I can get a workshop manual? I'm used to running 40's which were straight forward, so hope these turn out to be the same.
Also, I've noticed that these won't extend back fully after being compressed (can pull fork up 3-5mm) unless I have preload fully cranked. Any idea on what this may be? (stiction?) Currently running factory med spring.
Cheers,
Dave