need smoothie shock removal tips
shock needs rebuild. the front mount has what looks like pressed in screw. i called moots. i was told not to unbolt the front aluminum block, and just unscrew the front and rear.it would be nice if i had an exploded diagram to refer to. i may have to call them back, unless ya'll have any advise.
You may want to post this over on the forum that moots has on their website. Lots of answers from moots geeks there. I don't know the factory approved method, but i removed the linkages, which removes the upper mount. Then I, removed the lower shock piviot bolt, and drove the lower pivot out of the mount with a longer bolt, and a hammer, done. I don't think moots uses a hammer, but i'm just a garage hack. I'll hammer most anything.