First time user of this forum. Has anyone got any tips, do's and don't's for servicing the rear hub on a 2010 Attack Trail. The hub is unbranded, 12mm maxle and I assume 'sealed'. I have not touched one of these before and pretty much need to as I am getting some resistance to freewheel when 'in the hand'.
Is it a case of undoing the axle nuts and drifting the bearings? Service or replace depending on condition. I would like some recommends as per type / make of bearings also.
If in doubt I can go to LBS who are pretty good but I have some enforced time off and wan to stay busy.
Results 1 to 2 of 2
Thread: Attack Trail Rear Hub Service
Check out the hottest mountain bike products from these brands!
See All Interbike Coverage - Click Here »