Very new beginner question
So, I had an Ozark Trail 200 lumen flashlight take a dump on me. Turns out the switch went out. I removed the XB-D led from the circuitry, hoping to use it in a build.
What exactly am I going to need in order to make this happen, minus housing? I see talk of drivers and resisters, and while I have a basic understanding of electronic components from my years of guitar and amplifier repair, other than that, I'm at a loss.
Thanks for all your help!
In addition to the housing you'll need:
-thermal compound/thermal glue
You might not need all the parts, but most of them for sure.
Deciding on a driver depends on a battery setup you'll have. In case of 1S batt setup you'll need a linear type of driver like lflex or 7135 based driver, in case of 2+S setup you'll need a buck driver like bflex.
If you don't know where to search for the parts this would be a good place to start.
By ThePimento in forum Giant
Last Post: 09-08-2013, 06:53 PM
By jasonb751 in forum Beginner's Corner
Last Post: 04-30-2013, 07:07 PM
By Someformofhuman in forum Singlespeed
Last Post: 08-30-2012, 04:57 PM
By smac75 in forum Beginner's Corner
Last Post: 08-17-2012, 02:36 PM
By BigRed390 in forum Beginner's Corner
Last Post: 08-06-2012, 04:53 PM