Results 1 to 4 of 4

Thread: dx driver

  1. #1
    mtbr member
    Reputation:
    Join Date
    Jul 2008
    Posts
    166

    dx driver

    hi all
    i have these dx drivers that are battery +/- on the under side can you solder the +/- on the side as photo there are 2 solder pads G/G1 are they the battey +/-.



    cheer simon

  2. #2
    mtbr member
    Reputation:
    Join Date
    Oct 2008
    Posts
    1,295
    No. Not sure where to connect on the top of the driver, but those two pads don't work for +/- "in".

    We have some good EE types here. Hopefully one with chime in. I would like to solder to the top of the board as well.

  3. #3
    mtbr member
    Reputation:
    Join Date
    Jul 2010
    Posts
    56
    those both pads look to be both ground ie batt neg, as the outer ring on the other side, for positive i would say the hole in the center is when the positive passes though the pcb so the cap next to the hole in the center would be batt +

    Hope this helps, Ace

  4. #4
    mtbr member
    Reputation: yetibetty's Avatar
    Join Date
    Dec 2007
    Posts
    1,780
    thwang sorry I can't answer your question but you may want to check this post of odtaxas as I think you may have the same driver: 3.6V~9V 800mA Regulated IC Circuit Board

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •