Results 1 to 2 of 2
  1. #1
    Hack Racer
    Reputation: Cheers!'s Avatar
    Join Date
    Jun 2006

    Cutter Electronics - Cutter XR-E MR11 Kit Boost (Trim pot)

    For the guys here who have put together the Cutter XR-E MR11 Kit Boost kit... Did it come preset for the correct trim pot resistance (R1).

    I didn't check, and my multimeter is fubar and going back to Fluke under warranty. I just hooked it all up and powered it on. Was it set by cutter electronics to be at the right resistance?

  2. #2
    mtbr member
    Reputation: dnlwthrn's Avatar
    Join Date
    Jan 2006
    Mine was, but then I went and tried to tweak it... I finally got it back to close to the 13.5k setting, but it was a pain.

    Side note, my first housing is done. It looks like crap compared to some of the ones that have been posted so far, but it works! I'll be testing it out tomorrow on my commute to/from work.

Members who have read this thread: 0

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts



VISIT US AT and the ConsumerReview Network are business units of Invenda Corporation

(C) Copyright 1996-2018. All Rights Reserved.