7up board with driver built in

[sam2391]

what do you guys think of this, http://www.cutter.com.au/proddetail.php?prod=cut990 ?

I am right in thinking all I will need to do is get an optic, battery, switch and heatsink/housing and I will have a 7up xpg light?

[sam2391]

could this battery be used? http://www.xheli.com/98p-25c-5500-4s1p.html

[odtexas]

Yes, and yes.

[mmlvmm]

what do you guys think of this, http://www.cutter.com.au/proddetail.php?prod=cut990 ?

I am right in thinking all I will need to do is get an optic, battery, switch and heatsink/housing and I will have a 7up xpg light?

I got one of those boards and unfortunately cannot recomend it. Control on the dimming is iffy and the switch control points to solder are non existent little pin heads.

[quazzle]

sorry for being not fully correct recommending my own products, but what if you try 2-3 L333 boards linked as master-slave? There's a very nice housing done by Matt for a dual-board setup:
http://www.candlepowerforums.com/vb/...d.php?t=258699


when two A-types are used it may provide up to 2400 OTF lumens.

L333 all configurations (more that 70 options available): http://www.lux-rc.com/view.php?p=con...ht_engines/3UP

[sam2391]

Ok im interesed in this now! How much for a fully built kit to the UK? does it include a battery and charger? Thanks, Also how much is just a housing and switch etc?

[sam2391]

sorry didnt realise you just made the light engines, will definatly look into this though