Hope ProII - rear hub conversion

[SixZeroSixOne]

I'm contemplating switching from a 2010 to a 2012/13 Endorphin and trying to work out what parts I could swap over.

I know the new frame requires a 142x12 hub and my current Hope PROII is 135/QR but

http://www.chainreactioncycles.com/M...?ModelID=68578 shows two different product IDs for "12mm Bolt Thro" v "X12 Thro"

I'm not anticipating using a Maxle rear end, in case this is relevant so which one would I need to order?

Thanks

[qbert2000]

you want x12 that is for 142mm rear ends. there is a standard 12mmx135mm axle too.

[SixZeroSixOne]

Thanks!

[Calhoun]

Here is the one you need:

BTI | Hope Pro2 R hub convert kit, 12x142mm T-A

The conversion is pretty easy and you might look at replacing bearings while you have the hub apart.

[qbert2000]

Here is the one you need:

BTI | Hope Pro2 R hub convert kit, 12x142mm T-A

The conversion is pretty easy and you might look at replacing bearings while you have the hub apart.

yes, it is called the x12 conversion in that description from bti as well. same part from crc

Hope Conversion Kits Pro 2 X12 Rear | Buy Online | ChainReactionCycles.com

the "x12" designation refers to syntace's name for the 142mm system.

Syntace

[wilks]

What qbert said and takes all of 5 minutes to do the swap.

[Bullit_cn]

I been into the same questions before,
ProII will takes a lot of things to change not only the axle if you wish to convert it into 142x12
Only the ProII Evo is convertible with a simple axle or adaptor change,

[SixZeroSixOne]

Yeah, should have been a bit clearer...it is an Evo...

[Bullit_cn]

Qbert & Calhoun part mentioned below are correct then

[Calhoun]

If it is a Pro II EVO than this is what you need:

https://www.bti-usa.com/public/item/HT5863

at least that is how I understand it from reading this thread:

Hope Pro 2 Evo conversion 12mm

[Bullit_cn]

If it is a Pro II EVO than this is what you need:

https://www.bti-usa.com/public/item/HT5863

at least that is how I understand it from reading this thread:

That link above is only the adaptor for 12x135 converting to 142,
The link of Qbert below is the axle conversion from 9/10x135QR into 12x142

at least that is how I understand it too