Following on from a former thread - I went and had some new shock spacers made for my 6.6. At both ends, I had them made with the hole off-set as far as was possible (leaving enough metal around the hole in other words). In the end this amounted to just under 5mm combined (about 2.5mm off-set on each end of the shock). Sorry for the lack of picks but I can't be bothered pulling them off the bike and taking pics. I also didn't measure the BB height before vs after nor do know how to go about accurately measuring the head angle.
What I can tell you is that the result is fantastic. The HA is now perfect for an AM bike. I have an SS as well and i was not looking to get the 6.6 as slack as that. However, the plus minues one or so degree slacker head angle is very noticable as is the lower BB. All in all - it jus feels "right" where as it always felt almost right before. You just get that extra 10% confidence in hitting a corner hard or letting it rip on a steep DH.
If there is enough interest - I can get some made up and sell them. They were expensive as a one-off but the engineering place said the price would come down by as much as 50% if I wanted a bunch of 'em.
Results 1 to 8 of 8
Check out the hottest mountain bike products from these brands!
See All Interbike Coverage - Click Here »