Hello, I have a bos vip'r that I have mounted on my mojo hd frame, the problem is that this shock comes from another frame and the mounting hardware does not match completely: the upper bushing (mounted on the limbo chips) width was the same: 22 mm, but the lower one is a bit smaller, and I have to use some steel washers from the diy store...
It's running fine but I would like to have the correct mounting kit!
I've seen that some of you have this shock mounted on the hd, where did you get the mounting kit and which measures are needed?
Thanks a lot!
Results 1 to 3 of 3
Check out the hottest mountain bike products from these brands!
See All Interbike Coverage - Click Here »