Page 3 of 3 FirstFirst 1 2 3
Results 51 to 51 of 51

Thread: Round MTB Stays

  1. #51
    mtbr member
    Reputation:
    Join Date
    Jul 2009
    Posts
    61
    Hi Mark,

    Finally I did decided to use round 3/4x 0.035 for my own chainstays and deda stays for my girlfriend. I'll do some deflection tests on the rear end once they're done.

    What made me choose the 3/4 over the 7/8 is that deflection of a 17'' long, 3/4x0.035 steel tube with a 50 pounds force is 0.54'' and the deflection for titanium 7/8x0.035 is 0.62''.

    I know that bike tubes are subjected to more than just bending but I think it is a good indication. If TI with 7/8 rides well, steel with 3/4 should be good enough.

    And I use a 5.5 CLR die from JD2 for my 3/4 and my 7/8 too.
    Last edited by Golem builder; 01-08-2013 at 05:08 AM.
    Guillaume

    Cycles Golem

Page 3 of 3 FirstFirst 1 2 3

Similar Threads

  1. anyone try a Regina or lisa with Cutter round 10mm round mcpcb?
    By unterhausen in forum Lights DIY - Do It Yourself
    Replies: 24
    Last Post: 10-07-2010, 03:33 AM
  2. Replies: 39
    Last Post: 04-07-2010, 12:19 PM
  3. Quick question: flux stays = 06 spot stays???
    By swan lee in forum Turner
    Replies: 5
    Last Post: 01-28-2007, 01:04 PM
  4. Wishbone stays and A-stays..
    By mafia6 in forum General Discussion
    Replies: 0
    Last Post: 03-24-2006, 06:39 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •