Results 1 to 2 of 2
  1. #1
    mtbr member
    Reputation:
    Join Date
    Aug 2011
    Posts
    88

    Trigger 2929er bearing size

    Can anyone confirm the bearing size on the seatstys of a 2013 Trigger 29er 2? I measure the 10x20x7, but I can't pull the without a snap ring pliers. So I'm using calipers on the ID, OD and calculating the width...measuring 14.66mm for the two bearing at each pivot. The 4 bearings on the 15mm axles are 15x24x5 per the manual.

    Anybody have a definitive size?

    Thanks,

    Jason

  2. #2
    mtbr member
    Reputation:
    Join Date
    Aug 2011
    Posts
    88
    My Leatherman had small enough tips on pliers to get into and hold onto the snap rings without issue. So removing them was easy. The bearings are pressed in/out. I found a 3/4" socket, a 2" 1/4-20 bolt with a washer on the back of the socket and a washer/nut on the other side of the bearings pulled them out nicely.

    Bearings measure 10x19x5....I probably would have realized that if I had searched for a 10x20x7 and came up empty. At any rate, my bearings aren't bad, but I'll order a set in so they're on hand....along with a set of 15x24x5 for the linkages.

    Hope this helps someone. I couldn't find this information anywhere I looked. My LBS didn't know. Google wasn't helpful. MTBR didn't provide it until now either!

    Cheers,

    Jason

Similar Threads

  1. XT rear hub bearing size?
    By Dr.Mushy in forum Wheels and Tires
    Replies: 8
    Last Post: 03-01-2012, 03:11 PM
  2. Hope BB bearing size
    By banksd1983 in forum Drivetrain - shifters, derailleurs, cranks
    Replies: 3
    Last Post: 04-03-2011, 08:27 PM
  3. Bearing Size for 07 5.5
    By gottjr in forum Intense
    Replies: 0
    Last Post: 01-01-2011, 07:47 AM
  4. Replies: 7
    Last Post: 12-30-2010, 01:50 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •