Results 1 to 2 of 2
  1. #1
    mtbr member
    Reputation:
    Join Date
    Jul 2007
    Posts
    109

    magura rim brakes, altek levers

    does anyone know how to bleed these?
    edit: the master cylinder/lever assembly is all altek
    Last edited by jayssmtbde; 08-27-2008 at 11:47 PM.
    Two riders were approaching; and the wind began to howl.

  2. #2
    mtbr member
    Reputation: fervor_1's Avatar
    Join Date
    Aug 2005
    Posts
    315
    I have the same setup.

    You'll need a bleeder for maguras. You can use the factory bleed kit or a DYI setup. I use a syringe with a fitting that screws into the bleed port of the brakes. I got the fitting out of a box of brake parts (I think jagwire.) You'll also need mineral oil (like magura blood).

    Magura has bleed instructions on their website. It's the same procedure for your setup. Basically fill the syringe with fluid, knock out the air bubbles, screw into the brake, remove the bleed screw from the lever, and push fluid through the system. Once flushed, replace the bleed screw in the lever, remove syringe, and replace bleed screw on caliper. easy, but messy.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •