Results 1 to 3 of 3
  1. #1
    mtbr member
    Reputation:
    Join Date
    Oct 2005
    Posts
    323

    Installing internal routed brake

    What is the procedure for installing pre-bled brakes on an internally routed frame? Do I need to bleed all the fluid before installation, or can I just cut hose and thread it, not worrying about any fluid coming out? I understand that I will perform a bled after installation. Thx Pete

  2. #2
    mtbr member
    Reputation: Shalom's Avatar
    Join Date
    Nov 2008
    Posts
    1,994
    Guess it depends on the brake. If DOT, then I would completely drain the line. Mineral oil I might drain, depending on frame material.

  3. #3
    mtbr member
    Reputation:
    Join Date
    Apr 2012
    Posts
    1,575
    New, dry line through the frame. You will have to cut off a section of hose that includes the barb, so if you aren't sure you have extra length, that could create binding.

    At the very least, drain the line and put a turn on plastic wrap over the cut end, as you don't want any hydraulic fluids hanging out inside your frame.

Similar Threads

  1. Replies: 0
    Last Post: 10-10-2012, 04:35 PM
  2. Replies: 1
    Last Post: 08-07-2012, 01:06 PM
  3. Replies: 1
    Last Post: 08-07-2012, 07:59 AM
  4. Internally routed brake housing - pros and cons
    By rasse1977 in forum Brake Time
    Replies: 5
    Last Post: 01-17-2012, 12:07 PM
  5. Replies: 10
    Last Post: 06-02-2011, 04:36 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •